To make this props driveable you must first add it to these .ini files using notepad.
If they are not present in the ''props'' folder, use med (old and new) to extract them there.
Also make sure that the p_old_bus_v01.inf files is in the ''meshes/extrainfo'' folder


------------------------------
Add the name:

	p_old_bus_v01

to the following file(s):

car.ini
car_4_door.ini
car_4_door_w_chry.ini
car_jeep.ini
car_w_chry.ini


Note: Because of its size , shape and floor height, the regular driver and passengers sit way too low and are 
showing poking throught the floor.

A driver and passenger(s) static prop set should be used to fill the seats, but because they must be included as part of the car, 
and because of the infinite variations possible, this should be done as a special request.

There is no restriction for the static prop version of the bus, other than being able to only accomodate one driver used on the scroling car set. Careful positioning is required to line the driver with the steering wheel. 
Static passenger props could be used to fill the sideways facing seats.
------------------------------

	p_old_bus_v02

This is the same bus but is positionned below the set floor and is not driveable.
You dont have to add it to any ini and is available, like p_old_bus_v01, as a static prop for any sets.

p_old_bus_v01 sits on the set floor and can be raised but not lowered.

This Car, and its textures, was originaly made by MikeDBoing and should be credited as such.
The car was rendered driveable by MikeDBoing with Mr-Fixit(pre-beta) by Gleem from DCMF.
It was also formated and exported from 3DS Max with the Derobrash Mesh Script.

For any comments or requests,look me up on the forums at DCMF 

http://dcmodding.com (Home of Med)

Check my web site if your into airbrushing:

http://www.lino.com/~boing

Have fun!
I did

MikDBoing